Instructions / Assembly

9
3/8" X 3-1/4"
HEX BOLT
(A)
LARGE SPACER (MM)
PULLEY (NN)
3/8" LOCKWASHER (O)
3/8" HEX LOCK NUT (Z)
3/8"
WASHER (T)
LONG END
OF HUB
STEP 7: (SEE FIGURE 7)
• Attachthepulley(longendofhubfacingdown)and
the large spacer (MM) to the hole shown in the clutch/
idlerassembly.Usea3/8"x3-1/4"hexbolt(A),a3/8"
washer(T),a3/8"lockwasher(O)anda3/8"hexlock
nut (Z).
FIGURE 7
FIGURE 9
STEP 9: (SEE FIGURE 9)
• Attachthecablebrackettotheslotshowninthe
clutch/idlerassemblyusinga5/16"x3/4"carriage
bolt(K)anda5/16"nylocknut(Y).Placetheboltin
thefrontholeofthebracketandintheendoftheslot
closest to the pulley. Do not tighten yet.
CABLE
BRACKET
5/16" x 3/4"
CARRIAGE BOLT (K)
5/16" NYLOCK
NUT (Y)
THIS SECTION IS FOR TRACTORS WITH A
MANUAL ATTACHMENT CLUTCH
If your tractor has an electric attachment clutch go to
step 14 on page 11.
FIGURE 10
HEX BOLTS
(#48138)
DRIVE BELT
FLAT IDLER
PULLEYS
STOP
Didyouselectthecorrectdrivebeltforyour
tractor?Usingthewronglengthbeltmay
causeprematurebearingorbeltfailure.
STEP 10: (SEE FIGURE 10)
• Twodifferentlengthdrivebeltsareincludedwith
yoursnowthrower.Tractorswithmanualattachment
clutchesandsinglefrontdecksuspensionbracketsuse
the56"drivebeltwith#48138 printed on the outside of
thebelt.DO NOT USEtheotherbelt.
• Slightlyloosenthehexboltnexttotheatidlerpulley.
Installthedrivebeltdownbetweenthehexboltandthe
atidlerpulleywiththeatsideofthebeltagainstthe
pulley.Retightenthehexbolt.
• Loopthebeltaroundthelargev-pulley,placingit
betweenthev-pulleyandthehexboltnexttothepulley.
Placethebelttotheinsideoftheotheratidlerpulley.
5/16" NYLOCK
NUT (Y)
5/16" x 3/4"
HEX BOLT (C)
TENSIONING CHAIN (JJ)
FIGURE 8
STEP 8: (SEE FIGURE 8)
• Attachthetwosuspensionarmstotherearofthe
clutch/idlerassemblyusingtwo5/16"x3/4"hexbolts
(C)and5/16"nylocknuts(Y)foreacharm.Placethe
armsontheoutsideoftheframewiththenotchesto
the rear.
• Insertatensioningchainthroughtheholeshownand
attachtheendlinktothespringontheloweridlerarm.