Instructions / Assembly

8
STEP 4: (SEE FIGURE 4)
• Assembleashoulderbolt(L)anda3/8"washer(T)to
the outside of R.H. side plate, securing it with a 3/8"
angednut(X).RepeatforL.H.sideplate.
FIGURE 4 RIGHT SIDE VIEW
FIGURE 3 RIGHT SIDE VIEW
5/16"
NYLOCK
NUT (Y)
5/16" x 1"
CARRIAGE BOLT (J)
ENGINE MOUNTING
PLATE
(4) 1/2" WASHERS (R)
(3) 3/8" FLANGE NUTS (X)
(3) 3/8" x 1"
CARRIAGE
BOLTS (G)
SEE NOTE
3/8" WASHER (T)
SHOULDER
BOLT (L)
3/8" FLANGED
NUT (X)
INSTALL SIDE PLATES
STEP 3: (SEE FIGURE 3)
• FastentheR.H.SidePlate(bendfacingout)tothe
frontthreeholesinthetractorframeusingthree3/8"
x1"carriagebolts(G),three1/2"washers(R)(see
note)andthree3/8"angenuts(X). For the rear hole,
usea5/16"x1"carriagebolt(J),a1/2"washer(R)
anda5/16"nylocknut(Y). Place the 1/2" washers (R)
betweenthetractorframeandthesideplate.Repeat
for L.H. side plate.
• Reinstallthebrowningshieldontothetractorframe
using the original screws.
NOTE:Ifthereisanenginemountingplate(shownwith
dottedlines)leavethe1/2washerofftheboltthatgoes
through the plate.
INSTALL HANGER BRACKETS AND SHOULDER
BOLTS TO OUTSIDE OF FRAME
STEP 5: (SEE FIGURE 5)
• Removethebolt,ifpresent,intheholedirectlybehind
thebrakerodontheleftsideofthetractorframe.
• AttachtheL.H.HangerBracket(tubefacingout)tothe
holeusinga5/16"x3/4"selfthreadingbolt(F).
• Installaroundheadshoulderbolt(M)intothehole
thatis9-1/2"totherearoftheboltyoujustinstalled.
Secureitwitha3/8"angenut(X)ontheinsideofthe
frame.
FIGURE 5 LEFT SIDE VIEW
5/16" x 3/4" SELF
THREADING BOLT (F)
L.H. HANGER
BRACKET
BRAKE ROD
3/8" FLANGED
NUT (X)
SHOULDER
BOLT (M)
5/16" x 3/4" SELF
THREADING BOLT (F)
R.H. HANGER
BRACKET
RIGHT END OF
BRAKE ROD
3/8" FLANGED
NUT (X)
SHOULDER
BOLT (M)
STEP 6: (SEE FIGURE 6)
• Removethebracket,ifpresent,fromtheholedirectly
behindtheendofthebrakerodontherightsideof
thetractorframe.Storethebracketandbolt.
• AttachtheR.H.HangerBrackettotheholeusinga
5/16"x3/4"selfthreadingbolt(F).
• Installaroundheadshoulderbolt(M)intothehole
thatis9-1/2"totherearoftheboltyoujustinstalled.
Secureitwitha3/8"angenut(X)ontheinsideofthe
frame.
FIGURE 6 RIGHT SIDE VIEW