Instructions / Assembly

24
INSTALLING THE ATTACHMENT PIN
STEP 58: (REFER BACK TO FIGURE 54 ON PAGE 23)
• Liftthefrontofthesnowblowertoaligntheholesin
themountingplatesandthesideplates.Fromtheleft
sideofthetractorinserttheattachmentpinthrough
theholes.Secureitwithbyreinstallingthe1/8"hairpin
cotter (EE).
SETTING THE AUGER BELT TENSION
STEP 59: (SEE FIGURE 57)
• Pullthetensioningchainuntiltheendofthespringis
pulled through the hole in the side of the Clutch/Idler
assembly.Installa1/8"hairpincotter(EE)through
the end of the spring, securing it on the outside of the
Clutch/Idlerassembly.
IMPORTANT:Forcorrectbelttension,the 1/8" hairpin
cotter must attach to the end of the spring, not to the
chain.
NOTE;Topreventthechainfromdraggingonthe
ground,looptheendofthechainthoughthepivotlock
pin.Refertogure45onpage20.
FIGURE 57 VIEWED FROM UNDERNEATH
END OF
SPRING
1/8"
HAIRPIN
COTTER (EE)
LEFT SIDE
OF
TRACTOR
FLAT
PULLEY
CLUTCH/IDLER ASSEMBLY
REAR REFLECTORS (KK)
ATTACH REFLECTORS TO REAR FENDER
STEP 59: (SEE FIGURE 58)
• Ifyourtractorisnotequippedwithrearreectors,
assemblethesuppliedrearreectors(KK)totherear
fender.Placethereectorsasclosetothebottomof
the fender and as far apart as the shape of the fender
will allow.
FIGURE 58
CHECKLIST
Before you operate your snow thrower, please review the
following checklist to help ensure that you will obtain
the best performance from your snow thrower.
1. Allassemblyinstructionshavebeencompletedwithall
boltsandnutsproperlytightened.
2. Checktheenginebeltandtheaugerbelt.Makesure
they are routed properly around pulleys and inside all
beltkeepers.
3. Checkdischargechuteforproperrotation.
4. Checkoperationoftiltcontrolforupperchute.
5. Verifythatthelifthandlewilllockintoandreleasefrom
the raised transport position. (Refer to the Service and
Adjustmentssection.)
6. Checkskidshoeadjustment.(RefertotheServiceand
Adjustmentssection.)
Operating instructions begin on page 25.