Instructions / Assembly

20
FIGURE 46 VIEWED FROM UNDERNEATH
1/8" HAIRPIN
COTTER (EE)
ENGINE
PULLEY
ENGINE
PULLEY
Left Side
of Tractor
KEEPER
BOLT
IDLER
PULLEY
STEP 47: (SEE FIGURE 46)
• Assemblethedrivebeltontotheenginepulleyand
then onto the large pulley on top of the clutch/idler
assembly.Thebeltmustbeplacedtotheinsideof
theidlerpulleyandthekeeperboltlocatedbesidethe
large pulley.
• Placetensiononthebeltbypullingtheleftside
tensioning chain out as far as the 3/32" hairpin cotter
(FF)willallow.Securethechaininthispositionby
inserting a 1/8" hairpin cotter (EE) through the chain.
IMPORTANT: Do Notassemblethe"V"beltaroundthe
outsideoftheenginepulleykeeperorthekeeperbolt.
STEP 46: (SEE FIGURE 45)
• Attachtheclutch/idlerassemblytothetractorframe
asfollows.Hooktheassembly'snotchedarmsonto
thetwoshoulderboltsyouassembledtotheinside
ofthetractorframe.Liftthefrontoftheassemblyand
attachittotheR.H.andL.H.hangerbracketsusing
twopivotlockpins(GG)and1/8"hairpincotters(EE).
FIGURE 45 RIGHT SIDE VIEW
PIVOT LOCK PIN (GG)
(use second hole)
1/8" HAIRPIN COTTER (EE)
CLUTCH/IDLER ASSEMBLY
HEX BOLTS
DRIVE BELT
FLAT IDLER
PULLEY
FIGURE 44
STOP
Didyouchoosethecorrectdrivebeltfor
yourtractor?Usingthewronglengthbelt
maycauseprematurebearingorbeltfailure.
STEP 45: (SEE FIGURE 44)
• Turntheclutch/idlerassemblyrightsideup.
• Slightlyloosenthehexboltnexttotheatidlerpulley.
Installthedrivebeltdownbetweenthehexboltandthe
atidlerpulleywiththeatsideofthebeltagainstthe
pulley.Retightenthehexbolt.
• Loopthebeltaroundthelargev-pulley,placingit
betweenthev-pulleyandthehexboltnexttothepulley.
Placethebelttotheinsideoftheotheratidlerpulley.