Instructions / Assembly

17
FIGURE 36
FIGURE 38
STEP 36: (SEE FIGURE 36)
• Assemblethecablebrackettotheclutch/idler
assemblyusingtwo5/16"x3/4"carriagebolts(K)and
5/16"nylocknuts(Y).Usethetwofrontholesinthe
cablebracketifyourtractorhasa42"mowerdeck.
Usethetworearholesifyourtractorhasa46"mower
deck.
STEP 38: (SEE FIGURE 38)
• Movetheattachmentclutchleveronthedashpanelto
the disengaged (down) position.
• Placetheclutch/idlerassemblyontheoorontheright
side of the tractor.
• Attachthetractor'sclutchcabletothecablebracket.
Securethecablehousingguide(groovedown)tothe
cablebracketusingtheoriginalcollaranda5/64"hair
cotter pin (DD).
• Placeaspacer(LL)ontheweldedpinontheidlerarm.
Hooktheendoftheclutchspringoverthepinand
secure it with a 1/4" washer (P) and a 5/64" hair cotter
pin (DD).
CABLE
BRACKET
5/16" x 3/4"
CARRIAGE BOLT (K)
5/16" NYLOCK
NUT (Y)
42"
DECKS
46"
DECKS
TRACTOR'S
CLUTCH CABLE
5/64" HAIR
COTTER PIN (DD)
1/4" WASHER (P)
SPACER (LL)
5/64" HAIR
COTTER PIN (DD)
STEP 35: (SEE FIGURE 35)
• Attachthetwosuspensionarmstotherearofthe
clutch/idlerassemblyusingtwo5/16"x3/4"hexbolts
(C),5/16"washer(Q)and5/16"nylocknuts(Y)for
eacharm.Placethearmsontheoutsideoftheframe
with the notches to the rear.
• Insertatensioningchainthroughtheholeshownand
attachtheendlinktothespringontheloweridlerarm.
FIGURE 35
5/16" x 3/4"
HEX BOLT (C)
5/16" NYLOCK
NUT (Y)
TENSIONING CHAIN (JJ)
5/16" WASHER (Q)
CABLE OPERATED MANUAL ATTACHMENT CLUTCH
FIGURE 37
HEX BOLTS
DRIVE BELT
FLAT IDLER
PULLEY
(#46989)
STEP 37: (SEE FIGURE 37)
• Twodifferentlengthdrivebeltsareincludedwith
yoursnowthrower.Tractorswithmanualattachment
clutchesanddualfrontdecksuspensionbracketsuse
the55"drivebeltwith#46989 printed on the outside
ofthebelt.DO NOT USEtheotherbelt.
STOP
Didyouchoosethecorrectdrivebeltfor
yourtractor?Usingthewronglengthbelt
maycauseprematurebearingorbeltfailure.
• Slightlyloosenthehexboltnexttotheatidlerpulley.
Installthedrivebeltdownbetweenthehexboltandthe
atidlerpulleywiththeatsideofthebeltagainstthe
pulley.Retightenthehexbolt.
• Loopthebeltaroundthelargev-pulley,placingit
betweenthev-pulleyandthehexboltnexttothepulley.