Instructions / Assembly

12
STEP 19: (SEE FIGURE 18)
• Attachtheclutch/idlerassemblytothetractorframe.
Hookthenotchedsuspensionarmsontothetwo
shoulderbolts(M)assembledtotheoutsideofthe
tractorframe.Liftthefrontoftheassemblyandattach
ittotheR.H.andL.H.hangerbracketsusingtwopivot
lockpins(GG)and1/8"hairpincotters(EE).
PIVOT LOCK PIN (GG)
(use second hole)
SHOULDER
BOLT (M)
1/8" HAIRPIN
COTTER (EE)
L.H. HANGER
BRACKET
FIGURE 18 VIEWED FROM LEFT SIDE
STEP 20: (SEE FIGURE 19)
• Assemblethedrivebeltontotheenginepulleyrst
and then onto the large pulley on top of the clutch/
idlerassembly.Placethebelttotheinsideoftheidler
pulleyandthebeltkeeperboltlocatedbesidethe
large pulley.
• Placetensiononthebeltbypullingtheleftside
tensioning chain (JJ) out as far as the 3/32" hairpin
cotter in the chain will allow. Secure the chain in this
positionbyinsertinga1/8"hairpincotter(EE)through
the chain.
IMPORTANT: Do Notassemblethedrivebeltaroundthe
outsideofthekeeperboltbesidethelargepulley.
• Go to step 48 on page 21.
FIGURE 19 VIEWED FROM UNDERNEATH
1/8" HAIRPIN
COTTER (EE)
ENGINE
PULLEY
ENGINE
PULLEY
KEEPER
BOLT
IDLER
PULLEY
CHAIN (JJ)
(L.H. SIDE)
FIGURE 17
STEP 18: (SEE FIGURE 17)
• Turntheclutch/idlerassemblyrightsideup.
• Slightlyloosenthehexboltnexttotheatidlerpulley.
Installthedrivebeltdownbetweenthehexboltandthe
atidlerpulleywiththeatsideofthebeltagainstthe
pulley.Retightenthehexbolt.
• Loopthebeltaroundthelargev-pulley,placingit
betweenthev-pulleyandthehexboltnexttothepulley.
STOP
Didyouchoosethecorrectdrivebeltfor
yourtractor?Usingthewronglengthbelt
maycauseprematurebearingorbeltfailure.
CLUTCH/IDLER ASSEMBLY
HEX BOLTS
DRIVE BELT
FLAT IDLER
PULLEY