Instructions / Assembly

10
PIVOT LOCK PIN (GG)
(use this hole)
SHOULDER
BOLT (M)
L.H. HANGER
BRACKET
1/8" HAIRPIN
COTTER (EE)
NYLON TIE (II)
MOWER
CLUTCH
CABLE
FIGURE 12 VIEWED FROM LEFT SIDE
STEP 13: (SEE FIGURE 13)
• Assemblethedrivebeltontotheenginepulleyrst
and then onto the large pulley on top of the clutch/
idlerassembly.Thebeltmustbeplacedinsidethe
enginepulleybeltkeeper(s)andbetweenthelarge
pulleyandthekeeperboltnexttoit.
IMPORTANT: Do Notassemblethe"V"beltoutsideof
theenginepulleykeepersoroutsideofthekeeperbolt
next to the large pulley.
• Go to step 48 on page 21.
FIGURE 13 VIEWED FROM UNDERNEATH
ENGINE
PULLEY
ENGINE
PULLEY
Left Side
of Tractor
ENGINE
PULLEY
KEEPER
ENGINE
PULLEY
KEEPER
KEEPER BOLT
IDLER
PULLEY
CLUTCH/IDLER ASSEMBLY
FIGURE 11
5/64" HAIR
COTTER PIN
SPACER
1/4" WASHER
TRACTOR'S
CLUTCH CABLE
CABLE
BRACKET
GROOVE
5/64" HAIR
COTTER PIN (DD)
1/4" WASHER (P)
SPACER (LL)
TRACTOR'S
CLUTCH CABLE
CABLE
BRACKET
5/64" HAIR
COTTER PIN (DD)
ATTACH CLUTCH IDLER ASSEMBLY TO TRACTOR
STEP 12: (SEE FIGURE 12)
• Attachtheclutch/idlerassemblytothetractorframe.
Hookthenotchedsuspensionarmsontothetwo
shoulderbolts(M)assembledtotheoutsideofthe
tractorframe.Liftthefrontoftheassemblyandattach
ittotheR.H.andL.H.hangerbracketsusingtwopivot
lockpins(GG)and1/8"hairpincotters(EE).
• Looselyattachthemowerclutchcabletotheleftside
ofthetractorframewithanylontie(II).Do not pull
thenylontiecompletelytight.Thecablemayneedto
beremovedfromthenylontiewhenusingthemower
deck.
STEP 11: (SEE FIGURE 11)
• Findthecableclipthatisattachedtotheleftside
ofthetractorframeunderneaththefootrest.Open
theclipandremovethemowerclutchcable.Do not
removetheclipfromthetractorframe.Thecable
reattachestotheclipwhenusingthemowerdeck.
• Movetheattachmentclutchleveronthedashpanelto
the disengaged position.
• Placetheclutch/idlerassemblyontheoorontheleft
side of the tractor.
• Attachthetractor'smowerclutchcabletothecable
bracketontheclutch/idlerassembly.Securethecable
housingguide(groovedown)tothecablebracket
using the original collar and a 5/64" hair cotter pin (DD).
• Placeaspacer(LL)ontheweldedpinontheidler
arm.Hooktheendoftheclutchcablespringoverthe
pin and secure it with a 1/4" washer (P) and a 5/64"
hair cotter pin (DD).
• Aligncablebracketwithweldedpinandtightenthe
nutassembledinstep9.