Instructions / Assembly

9
STEP 7: (SEE FIGURE 7)
• Attachthecablebrackettothedoubleholeinthe
clutchframeasshown,usinga5/16"x3/4"carriage
boltanda5/16"nylocknut.Placetheboltinthefront
holeofthebracketandintheendoftheholeclosest
to the pulley. Do not tighten yet.
FIGURE 7
FIGURE 9
STEP 9: (SEE FIGURE 9)
• Attacheachrearpulleyframebrackettotheinside
oftheclutchframeusingtwo5/16"x3/4"hexbolts,
5/16"washersand5/16"nylocknuts.
• Attacheachfrontpulleyframebrackettotheinsideof
theclutchframeusingtwo5/16"x1"hexbolts,four
5/16"washersandtwo5/16"nylocknuts.
THIS SECTION IS FOR TRACTORS WITH A
MANUAL ATTACHMENT CLUTCH
If your tractor has an electric attachment clutch go to
step 14 on page 11.
FIGURE 10
STOP
Didyouselectthecorrectdrivebeltforyour
tractor?Usingthewronglengthbeltmay
causeprematurebearingorbeltfailure.
STEP 10: (SEE FIGURE 10)
• Twodifferentlengthdrivebeltsareincludedwithyour
snowthrower.Usethelonger,56"drivebelt(#48138)
ontractorswithmanualattachmentclutches.
• Slightlyloosenthehexboltnexttotheatidlerpulley.
Installthedrivebeltdownbetweenthehexboltandthe
atidlerpulleywiththeatsideofthebeltagainstthe
pulley.Retightenthehexbolt.
• Loopthebeltaroundthelargev-pulley,placingit
betweenthev-pulleyandthehexboltnexttothepulley.
Placethebelttotheinsideoftheotheratidlerpulley.
FIGURE 8
STEP 8: (SEE FIGURE 8)
• Attachthepulley(longendofhubfacingdown)and
thelarge3/8"spacertotheclutchframe.Usea3/8"x
3-1/4"hexbolt,a3/8"washer,a3/8"lockwasheranda
3/8"hexlocknut.
• Installatensioningchainthroughtheholeshownand
theninserta3/32"hairpincotterintothe4thlink.
• Attachthechaintothespringontheloweridlerarm.
CABLE
BRACKET
5/16" x 3/4"
CARRIAGE BOLT
5/16" NYLOCK
NUT
5/16" x 1"
HEX BOLT
5/16" x 3/4"
HEX BOLT
5/16"
NYLOCK
NUT
5/16" WASHER
(2) 5/16"
WASHERS
HEX BOLTS
(#48138)
DRIVE BELT
FLAT IDLER
PULLEYS
LARGE 3/8" SPACER
3/8" LOCKWASHER
3/8" HEX LOCK NUT
3/8" WASHER
3/8" x 3-1/4"
HEX BOLT
TENSIONING
CHAIN
PULLEY
(long end of
hub down)
3/32" HAIRPIN COTTER
IN 4TH LINK