Instructions / Assembly

8
STEP 4: (SEE FIGURE 4)
• Installashoulderbolt,a3/8"washeranda3/8"
angedlocknutintheR.H.andL.H.SidePlates.
FIGURE 4 RIGHT SIDE VIEW
FIGURE 3 RIGHT SIDE VIEW
5/16"
NYLOCK
NUT
5/16" x 1"
CARRIAGE BOLT
ENGINE MOUNTING
PLATE
(4) 1/2" WASHERS
(3) 3/8" FLANGE NUTS
(3) 3/8" x 1"
CARRIAGE
BOLTS
SEE NOTE
INSTALL SIDE PLATES
STEP 3: (SEE FIGURE 3)
• FastentheR.H.SidePlate(bendfacingout)tothe
frontthreeholesinthetractorframeusingthree3/8"
x1"carriagebolts,three1/2"washers(seenote)and
three3/8"angenuts. For the rear hole, use a 5/16" x
1"carriagebolt,a1/2"washeranda5/16"nylocknut.
Placethe1/2"washersbetweenthetractorframeand
the side plate. Repeat for L.H. side plate.
• Reinstallthebrowningshieldontothetractorframe
using the original screws.
NOTE:Ifthereisanenginemountingplate(shownwith
dottedlines)leavethe1/2washerofftheboltthatgoes
through the plate.
INSTALL HANGER BRACKETS AND SHOULDER
BOLTS TO OUTSIDE OF FRAME
STEP 5: (SEE FIGURE 5)
• Removethebolt,ifpresent,intheholedirectlybehind
thebrakerodontheleftsideofthetractorframe.
• AttachtheL.H.HangerBracket(tubefacingout)tothe
holeusinga5/16"x3/4"selfthreadingbolt.
• Installashoulderboltintotheholethatis9-1/2"tothe
rearoftheboltyoujustinstalled.Secureitwitha3/8"
angenutontheinsideoftheframe.
FIGURE 5 LEFT SIDE VIEW
5/16" x 3/4" SELF
THREADING BOLT
L.H. HANGER
BRACKET
BRAKE ROD
3/8" FLANGED NUT
SHOULDER
BOLT
5/16" x 3/4" SELF
THREADING BOLT
R.H. HANGER
BRACKET
RIGHT END OF
BRAKE ROD
3/8" FLANGED
NUT
SHOULDER
BOLT
STEP 6: (SEE FIGURE 6)
• Removethebracket,ifpresent,fromtheholedirectly
behindtheendofthebrakerodontherightsideof
thetractorframe.Storethebracketandbolt.
• AttachtheR.H.HangerBrackettotheholeusinga
5/16"x3/4"selfthreadingbolt.
• Installashoulderboltintotheholethatis9-1/2"tothe
rearoftheboltyoujustinstalled.Secureitwitha3/8"
angenutontheinsideoftheframe.
FIGURE 6 RIGHT SIDE VIEW
3/8" WASHER
SHOULDER
BOLT
3/8" FLANGED
NUT