Instructions / Assembly

23
STEP 55: (SEE FIGURE 54)
• Placethesnowthroweronaat,levelsurface.
• Extendtheaugerbeltoutbehindthesnowthrower,
keepingthebeltassembledtothesnowthrowerpulleys.
• Rollthetractorupbehindthesnowthrower,centering
itbetweenthesnowthrower'smountingplates.
• Raisetherearofthesnowthrowerbyliftingupon
thelifthandleuntilthenotchesinthemountingplates
alignwiththeshoulderboltsinthetractor'sside
plates.Guidetheboltsintothenotches.
• Delayinstallingtheclevispinsuntilyouhave
assembledthebeltasinstructedinsteps56and57.
ATTACHING SNOW THROWER TO TRACTOR
STEP 56: (SEE FIGURE 55)
• Theaugerbeltcomespre-assembledtothepulleyson
thesnowthrowerhousing.Makesurethebeltpasses
over the top of the auger pulley and then twists 1/4
turn to pass underneath each side idler pulley. The
"V"sideofthebeltmustmatewiththegroovesofthe
pulleys.
IDLER
PULLEY
AUGER PULLEY
TWIST
1/4 TURN
TWIST
1/4 TURN
IDLER
PULLEY
FIGURE 55
FIGURE 54 RIGHT SIDE VIEW
BELT ROUTING DIAGRAM
ENGINE PULLEY
1/8" HAIRPIN
COTTER
MOUNTING
PLATE
SIDE PLATE
CLEVIS PIN
1/2" x 7/8"
SHOULDER
BOLT
FIGURE 56 VIEWED FROM UNDERNEATH
STEP 57: (SEE FIGURE 56)
• Pushthelifthandledowntoincreaseslackinthebelt.
• Swingtheloweridlerarmovertotheleftside.
• Slightlyloosenthebeltkeeperboltslocatedbeside
theidlerarmV-pulleyandtherearV-pulley.
• PlacetheaugerbeltaroundtherearV-pulleyand
betweenthetwopulleysontheidlerarm.The"V"
sideofthebeltmustbeseatedinthegroovesofthe
V-pulleys.
• Retightenthetwokeeperbolts.
LEFT SIDE
OF TRACTOR
KEEPER
BOLT
IDLER ARM V-PULLEY
IDLER ARM
FLAT PULLEY
KEEPER
BOLT
NUT