Instructions / Assembly

20
FIGURE 46 VIEWED FROM UNDERNEATH
STEP 47: (SEE FIGURE 46)
• Assemblethedrivebeltontotheenginepulleyand
then onto the large pulley on top of the clutch/idler
assembly.Thebeltmustbeplacedtotheinsideof
theidlerpulleyandthekeeperboltlocatedbesidethe
large pulley.
• Placetensiononthebeltbypullingtheleftside
tensioning chain out as far as the 3/32" hairpin cotter
willallow.Securethechaininthispositionbyinserting
a 1/8" hairpin cotter through the chain.
IMPORTANT: Do Notassemblethe"V"beltaroundthe
outsideoftheenginepulleykeeperorthekeeperbolt.
STEP 46: (SEE FIGURE 45)
• Attachtheclutch/idlerassemblytothetractorframeas
follows.Hooktheassembly'snotchedarmsontothe
twoshoulderboltsyouassembledtotheinsideofthe
tractorframe.Liftthefrontoftheassemblyandattach
ittotheR.H.andL.H.hangerbracketsusingtwopivot
lockpinsand1/8"hairpincotters.
FIGURE 45 RIGHT SIDE VIEW
CLUTCH/IDLER ASSEMBLY
FIGURE 44
STOP
Didyouchoosethecorrectdrivebeltfor
yourtractor?Usingthewronglengthbelt
maycauseprematurebearingorbeltfailure.
STEP 45: (SEE FIGURE 44)
• Turntheclutch/idlerassemblyrightsideup.
• Slightlyloosenthehexboltnexttotheatidlerpulley.
Installthedrivebeltdownbetweenthehexboltandthe
atidlerpulleywiththeatsideofthebeltagainstthe
pulley.Retightenthehexbolt.
• Loopthebeltaroundthelargev-pulley,placingit
betweenthev-pulleyandthehexboltnexttothepulley.
DRIVE BELT
FLAT IDLER
PULLEY
HEX BOLTS
PIVOT LOCK PIN
(use second hole)
1/8" HAIRPIN COTTER
1/8" HAIRPIN
COTTER
ENGINE
PULLEY
ENGINE
PULLEY
Left Side
of Tractor
KEEPER
BOLT
IDLER
PULLEY