Instructions / Assembly

19
ELECTRIC ATTACHMENT CLUTCHES
FIGURE 42
FIGURE 43 VIEW OF BOTTOM
STEP 43: (SEE FIGURE 43)
• Attachthetworearpulleyframebracketstotheinside
oftheclutch/idlerassemblyusingtwo5/16"x1"hex
bolts,eight5/16"washersandtwo5/16"nylocknuts
foreachbracket.
• Attachthetwofrontpulleyframebracketstotheinside
oftheclutch/idlerassemblyusingtwo5/16"x3/4"hex
bolts,5/16"washersand5/16"nylocknutsforeach
bracket.
STEP 44: (SEE TABLE 2)
• Twodifferentlengthdrivebeltsareincludedwith
yoursnowthrower.Usethetablebelowtoselect
thecorrectdrivebeltforyourtypetractor.Thepart
numberisprintedontheoutsideofthebelt.
• Setasidethebeltthatisnotforyourtractortoavoid
accidentally using it.
55" BELT (PART #46989)
TRACTOR TYPE DECK SIZE CLUTCH TYPE
56" BELT (PART #48138)
TRACTOR TYPE DECK SIZE CLUTCH TYPE
(LT) Lawn Tractor 48" Electric
(LT) Lawn Tractor 38", 42", 46" Electric
TABLE 2
STEP 41: (SEE FIGURE 41)
• Turntheclutchidlerassemblyupsidedown.
• Hookthelongendofthespringontotheendofthe
boltthatextendsthroughthenutonthebottomofthe
upperidlerarm.Installa3/8"hexlocknutontothebolt,
leaving enough space for the spring to pivot.
FIGURE 41
STEP 42: (SEE FIGURE 42)
• Inserttensioningchainsthroughtheholesshownand
attachtothespringsontheupperandloweridlerarms.
• Installa3/32"hairpincotterinthe5thlinkofthechain
attachedtotheupperidlerarm.
• Installa3/32"hairpincotterinthe4thlinkofthechain
attachedtotheloweridlerarm.
3/8" HEX
LOCK NUT
SPRING
ATTACH
LONG
END OF
SPRING
HERE
TENSIONING CHAIN
(lower idler arm)
TENSIONING CHAIN
(upper idler arm)
3/32" HAIRPIN
COTTER IN
5th LINK
3/32" HAIRPIN COTTER
IN 4th LINK
5/16" x 3/4" HEX BOLT
5/16" x 1"
HEX BOLT
5/16" NYLOCK NUT
5/16"
WASHER
(4) 5/16" WASHERS