Instructions / Assembly

18
FIGURE 40 VIEWED FROM UNDERNEATH
FIGURE 39
STEP 40: (SEE FIGURE 40)
• Assembletheshort"V"beltontotheenginepulley
and then onto the large pulley on top of the clutch/idler
assembly.Thebeltmustbeplacedtotheinsideofthe
enginepulleykeeper,theidlerpulleyandthekeeper
boltlocatedbesidethelargepulley.
IMPORTANT: Do Notassemblethe"V"beltaroundthe
outsideoftheenginepulleykeeperorthekeeperbolt.
• Go to step 48 on page 21.
STEP 39: (SEE FIGURE 39)
• Removetheenginepulleykeeperfromthesideof
thetractorframebyremovingthewasherandnut
thatsecurethekeeper.Attachthenewpulleykeeper
supplied with the snow thrower, reusing the original
bolt,washerandnut.
NOTE:Sometractorsmayalreadybeequippedwitha
pulleykeeperthatisidenticaltothenewonesupplied.
• Attachtheclutch/idlerassemblytothetractorframe
asfollows.Hooktherearoftheassemblyontothetwo
shoulderboltsyouinstalledonthetractorframe.Lift
thefrontoftheassemblyandattachittothehanger
bracketsyouinstalledusingtwopivotlockpinsand
1/8" hairpin cotters.
FIGURE 38
STEP 38: (SEE FIGURE 38)
• Movetheattachmentclutchleveronthedashpanelto
the disengaged (down) position.
• Placetheclutch/idlerassemblyontheoorontheright
side of the tractor.
• Attachthetractor'sclutchcabletothecablebracket.
Securethecablehousingguide(groovedown)tothe
cablebracketusingtheoriginalcollaranda5/64"hair
cotter pin.
• Placeaspacerontheweldedpinontheidlerarm.
Hooktheendoftheclutchspringoverthepinand
secure it with a 1/4" washer and a 5/64" hair cotter pin.
5/64" HAIR
COTTER PIN
1/4" WASHER
TRACTOR'S
CLUTCH CABLE
5/64" HAIR
COTTER PIN
SPACER
NEW ENGINE PULLEY KEEPER WITH
ORIGINAL BOLT, NUT AND WASHER
PIVOT LOCK PIN
(use second hole)
1/8" HAIRPIN COTTER
ENGINE
PULLEY
KEEPER BOLT
IDLER
PULLEY
ENGINE
PULLEY
KEEPER
Left Side
of Tractor