Instructions / Assembly

17
FIGURE 36
STEP 35: (SEE FIGURE 35)
• Assemblethecablebrackettoinnerpartofthedouble
holesintheclutch/idlerassemblyusingtwo5/16"x
3/4"carriageboltsand5/16"nylocknuts.Usethetwo
frontholesinthecablebracketfor42"mowerdecks.
Usethetworearholesfor46"mowerdecks.
STEP 36: (SEE FIGURE 36)
• Attachthetworearpulleyframebracketstotheinsideof
theclutch/idlerassemblyusingtwo5/16"x1"hexbolts,
eight5/16"washersandtwo5/16"nylocknutsforeach
bracket.
• Attachthetwofrontpulleyframebracketstotheinside
oftheclutch/idlerassemblyusingtwo5/16"x3/4"hex
bolts,5/16"washersand5/16"nylocknutsforeach
bracket.Addextrawashersifneededinstep39.
• Insertatensioningchainthroughtheholeshownand
attachtheendlinktothespringontheloweridlerarm.
• Installa3/32"hairpincotterinthe4thlinkofthechain.
FIGURE 35
CABLE OPERATED MANUAL ATTACHMENT CLUTCH
FIGURE 37
HEX BOLTS
DRIVE BELT
FLAT IDLER
PULLEY
(#46989)
STEP 37: (SEE FIGURE 37)
• Twodifferentlengthdrivebeltsareincludedwith
yoursnowthrower.Tractorswithmanualattachment
clutchesanddualfrontdecksuspensionbracketsuse
the55"drivebeltwith#46989 printed on the outside
ofthebelt.DO NOT USEtheotherbelt.
• Slightlyloosenthehexboltnexttotheatidlerpulley.
Installthedrivebeltdownbetweenthehexboltandthe
atidlerpulleywiththeatsideofthebeltagainstthe
pulley.Retightenthehexbolt.
• Loopthebeltaroundthelargev-pulley,placingit
betweenthev-pulleyandthehexboltnexttothepulley.
STOP
Didyouchoosethecorrectdrivebeltfor
yourtractor?Usingthewronglengthbelt
maycauseprematurebearingorbeltfailure.
CABLE
BRACKET
5/16" x 3/4"
CARRIAGE BOLT
5/16" NYLOCK
NUT
42"
DECKS
46"
DECKS
TENSIONING CHAIN
(lower idler arm)
5/16" x 3/4"
HEX BOLT
5/16" x 1"
HEX BOLT
5/16" NYLOCK NUT
5/16"
WASHER
(4) 5/16" WASHERS
3/32" HAIRPIN
COTTER IN
4th LINK