Instructions / Assembly

16
FIGURE 33 RIGHT SIDE VIEW
FIGURE 32 RIGHT SIDE VIEW
STEP 33: (SEE FIGURE 33)
• Makesuretheattachmentclutchleveronthedash
panel is in the disengaged (down) position.
• Pivottheupperidlerarmsothatitrestsagainst
thestopboltandispointingtowardthefrontas
shown. Screw the trunnion along the threads of the
engagementroduntilitisalignedatthefrontendof
theidlerarmslot.Attachthetrunniontotheslotusing
the 3/8" thin washer and a 5/64" hairpin cotter.
• Removetheenginepulleykeeperfromthesideof
thetractorframebyremovingthewasherandnut
thatsecurethekeeper.Attachthenewpulleykeeper
supplied with the snow thrower, reusing the original
bolt,washerandnut.
NOTE:Sometractorsmayalreadybeequippedwitha
pulleykeeperthatisidenticaltothenewonesupplied.
IDLER ARM
5/64" HAIRPIN
COTTER
TRUNNION
STOP BOLT
3/8" THIN
WASHER
NEW ENGINE PULLEY KEEPER WITH
ORIGINAL BOLT, NUT AND WASHER
STEP 34: (SEE FIGURE 34)
• Assembletheshort"V"beltontotheenginepulley
and then onto the large pulley on top of the clutch/idler
assembly.Thebeltmustbeplacedtotheinsideofthe
enginepulleykeeper,theidlerpulleyandthekeeper
boltlocatedbesidethelargepulley.
IMPORTANT: Do Notassemblethe"V"beltaroundthe
outsideoftheenginepulleykeeperorthekeeperbolt.
• Go to step 48 on page 21.
FIGURE 34 VIEWED FROM UNDERNEATH
CLUTCH/IDLER ASSEMBLY
STEP 32: (SEE FIGURE 32)
• Besuretoliftupthefrontendoftheengagementrod
asshownwhenperformingthenextoperation.You
cantemporarilysupporttherodusingarubberband
tiedtotheenginepulleykeeper.
• Attachtheclutch/idlerassemblytothetractorframe
asfollows.Hooktheassembly'snotchedrearpulley
framebracketsontothetwoshoulderboltsyou
assembledtotheinsideofthetractorframe.Liftthe
frontoftheassemblyandattachittotheR.H.andL.H.
hangerbracketsusingtwopivotlockpinsand1/8"
hairpin cotters.
PIVOT LOCK PIN (MM)
(use second hole)
1/8" HAIRPIN COTTER
ENGAGEMENT
ROD
ENGINE
PULLEY
KEEPER BOLT
IDLER
PULLEY
ENGINE
PULLEY
KEEPER
Left Side
of Tractor