Instructions / Assembly

13
STEP 22: (SEE FIGURE 21)
• FastentheR.H.SidePlate(bendfacingout)tothe
frontthreeholesshowninthetractorframeusing
three3/8"x1"threadformingbolts,three3/8"lock
washers and one 1/2" washer. Place the washer on
thethirdboltasashimbetweenthesideplateand
theframe.Tightenallbolts.RepeatfortheL.H.side.
NOTE:Ifyouinstalledaboltinthefourthholeinstep21,
assemblea5/16"angenutontotheboltaftertheside
plate is installed.
• Go to step 25 on this page.
(3) 3/8" x 1"
THREAD FORMING
BOLTS
5/16" FLANGED
NUT
(SEE NOTE)
(3) 3/8" LOCK
WASHERS
1/2" WASHER
5/16" x 1"
CARRIAGE BOLT
(SEE NOTE)
FIGURE 21 RIGHT SIDE VIEW
FRONT SUSPENSION
BRACKET
REMOVE BOLTS
IF PRESENT
FIGURE 22 RIGHT SIDE VIEW
STEP 23: (SEE FIGURE 22)
• Removeanyboltsfoundintheholesshown.
STEP 21: (SEE FIGURE 20)
• Removeboltsfromfrontthreeholesshown.
• Ifaboltispresentinthefourthhole,replaceitwith
a5/16"x1"carriageboltwithoutanut.Thebracket
fastenedtoinsideofframemustremaininplace.
FRONT
SUSPENSION
BRACKET
REPLACE BOLT
(IF PRESENT)
REMOVE BOLTS
(IF PRESENT)
FIGURE 20 RIGHT SIDE VIEW
INSTRUCTIONS FOR TRACTORS WITH DUAL
FRONT DECK SUSPENSION BRACKETS
FASTEN SIDE PLATES TO TRACTOR
Ifyourtractorresemblesgure20,startwithstep21.
Ifyourtractorresemblesgure22,startwithstep23.
STEP 25: (SEE FIGURE 24)
• Installahexheadshoulderbolt,a3/8"washeranda
3/8"angedlocknutintheR.H.andL.H.SidePlates.
FIGURE 24 RIGHT SIDE VIEW
3/8" WASHER
SHOULDER
BOLT
3/8" FLANGED
NUT
STEP 24: (SEE FIGURE 23)
• FastentheR.H.SidePlate(bendfacingout)tothe
threeholesshowninthetractorframe.Usethree3/8"
x1"threadformingbolts,3/8"lockwashersand1/2"
washers.Usethe1/2"washersasshimsbetweenthe
SidePlateandthetractorframe.Tightenallboltsand
repeat for the L.H. side.
NOTE:Iftheboltinsertsfreelyintothefronthole,assemble
a3/8"angednutontothebolt.
(3) 3/8" x 1"
THREAD FORMING
BOLTS
(3) 3/8" LOCK
WASHERS
3/8" FLANGED NUT
(SEE NOTE)
(3) 1/2" WASHERS
FIGURE 23 RIGHT SIDE VIEW