Instructions / Assembly

12
STEP 19: (SEE FIGURE 18)
• Hooktherearoftheclutch/idlerassemblyontothe
twoshoulderboltsassembledtotheoutsideofthe
tractorframe.Liftthefrontoftheassemblyandattach
ittotheR.H.andL.H.hangerbracketsusingtwopivot
lockpinsand1/8"hairpincotters.
FIGURE 18 VIEWED FROM LEFT SIDE
FIGURE 19 VIEWED FROM UNDERNEATH
FIGURE 17
STEP 18: (SEE FIGURE 17)
• Turntheclutch/idlerassemblyrightsideup.
• Slightlyloosenthehexboltnexttotheatidlerpulley.
Installthedrivebeltdownbetweenthehexboltandthe
atidlerpulleywiththeatsideofthebeltagainstthe
pulley.Retightenthehexbolt.
• Loopthebeltaroundthelargev-pulley,placingit
betweenthev-pulleyandthehexboltnexttothepulley.
STOP
Didyouchoosethecorrectdrivebeltfor
yourtractor?Usingthewronglengthbelt
maycauseprematurebearingorbeltfailure.
DRIVE BELT
FLAT IDLER
PULLEY
HEX BOLTS
PIVOT LOCK PIN
(use second hole)
SHOULDER
BOLT
1/8" HAIRPIN
COTTER
L.H. HANGER
BRACKET
1/8"
HAIRPIN
COTTER
ENGINE
PULLEY
HEX BOLTS
FLAT IDLER
PULLEY
TENSIONING
CHAIN
LEFT SIDE
OF TRACTOR
STEP 20: (SEE FIGURE 19)
• Assemblethedrivebeltontotheenginepulley.You
mayneedtoremovethebeltfromthelargepulleyon
theclutch/idlerassemblyinordertoassembleitonto
theenginepulley.Whenre-assemblingthebeltonto
thelargepulley,besurethebeltisbetweenthelarge
pulleyandthehexboltnexttoit.
• Placetensiononthebeltbypullingtheleftside
tensioning chain out as far as the 3/32" hairpin cotter
that was installed in the chain in step 15 will allow.
Securethechaininthispositionbyinsertinga1/8"
hairpin cotter through the chain.
NOTE;Topreventthechainfromdraggingonthe
ground,looptheendofthechainthoughthepivotlock
pin. Refer to gure 56 on page 23.
• Go to step 48 on page 21.