Instructions / Assembly

10
FIGURE 12 VIEWED FROM LEFT SIDE
STEP 13: (SEE FIGURE 13)
• Assemblethedrivebeltontotheenginepulleyrst
and then onto the large pulley on top of the clutch/idler
assembly.Thebeltmustbeplacedinsidetheengine
pulleybeltkeeper(s)andbetweenthelargepulleyand
thekeeperboltnexttoit.
IMPORTANT: Do Notassemblethe"V"beltoutsideof
theenginepulleykeepersoroutsideofthekeeperbolt
next to the large pulley.
• Go to step 48 on page 21.
FIGURE 13 VIEWED FROM UNDERNEATH
CLUTCH/IDLER ASSEMBLY
FIGURE 11
ATTACH CLUTCH IDLER ASSEMBLY TO TRACTOR
STEP 12: (SEE FIGURE 12)
• Hooktherearoftheclutch/idlerassemblyontothe
twoshoulderboltsassembledtothetractorframe.
LiftthefrontoftheassemblyandattachittotheR.H.
andL.H.hangerbracketsusingtwolockpinsand1/8"
hairpin cotters.
• Looselyattachthemowerclutchcabletotheleftside
ofthetractorframewithanylontie.Do not pull the
nylontiecompletelytight.Thecablemayneedtobe
removedfromthenylontiewhenusingthemower
deck.
STEP 11: (SEE FIGURE 11)
• Findthecableclipthatisattachedtotheleftside
ofthetractorframeunderneaththefootrest.Open
theclipandremovethemowerclutchcable.Do not
removetheclipfromthetractorframe.Thecable
reattachestotheclipwhenusingthemowerdeck.
• Movetheattachmentclutchleveronthedashpanelto
the disengaged position.
• Placetheclutch/idlerassemblyontheoorontheleft
side of the tractor.
• Attachthetractor'smowerclutchcabletothecable
bracketontheclutch/idlerassembly.Securethecable
housingguide(groovedown)tothecablebracket
using the original collar and a 5/64" hair cotter pin.
• Placethesmallspacerontheweldedpinontheidler
arm.Hooktheendoftheclutchcablespringoverthe
pin and secure it with a 1/4" washer and a 5/64" hair
cotter pin.
• Aligncablebracketwithweldedpinandtightenthe
nutassembledinstep7.
PIVOT LOCK PIN
(use this hole)
SHOULDER
BOLT
L.H. HANGER
BRACKET
1/8" HAIRPIN
COTTER
NYLON TIE
MOWER
CLUTCH
CABLE
5/64" HAIR
COTTER PIN
1/4" WASHER
1/4" SPACER
5/64" HAIR
COTTER PIN
TRACTOR'S
CLUTCH CABLE
CABLE
BRACKET
ENGINE
PULLEY
ENGINE
PULLEY
Left Side
of Tractor
ENGINE
PULLEY
KEEPER
ENGINE
PULLEY
KEEPER
KEEPER BOLT
IDLER
PULLEY