Instruction Manual

FIGURE 9

12. To align the elbow with the opening in the hard top:

a. Push the vinyl boot back inside the opening.

b. Loosen by approximately 1/2 turn each, the six

bolts from Step 10 that fasten the engine base to the

tongue.

c. Slide the engine base assembly to the right until

the elbow is aligned with the opening in the hardtop.

d. Retighten the six bolts that were loosened.

13. Pull the vinyl boot onto the end of the elbow.

5/16" x 3/4"

SELF THREADING

HEX BOLT

NYLON WASHER

FIGURE 8

11. Assemble the elbow to the impeller housing using

four 5/16" x 3/4" self tapping hex bolts and four nylon

washers. Push while turning to help start the bolts into

the un-threaded holes. Tighten. See gure 8.

Loosen (6) bolts

1/2 turn each

Align elbow with opening

Slide engine

mount to the

right to align

elbow