Instruction Manual

8
FIGURE 4
5. Assemble a spacer tube, a 1" at washer, a wheel
(valve stem facing out), and another 1" at washer
onto the axle as shown in gure 4. Secure the wheel
with a cotter pin, spreading the ends of the pin.
Repeat on other end of axle.
6. Pump grease into grease ttings on wheels until
grease is forced out through ends of hubs.
COTTER
PIN
WHEEL
1" FLAT
WASHER
1" FLAT
WASHER
SPACER
TUBE
FIGURE 5
7. Tip the cart forward so that it rests on its wheels.
8. Assemble the front tongue on top of the rear tongue
using four 3/8" x 1-1/4" hex bolts, 3/8" lock washers
and 5/16" at washers. See gure 5.
HINT: For easier assembly, support the rear tongue with
a block of wood.
BLOCK
3/8" x 1-1/4"
HEX BOLT
3/8" LOCK
WASHER
5/16" FLAT
WASHER
9. Secure the hitch pin to the hitch bracket and tongue
with the hair cotter pin. See gure 6.
FIGURE 6
HITCH
PIN
HAIR
COTTER
PIN
10. Attach the engine base assembly to the tongue using
four 3/8" x 3-1/4" hex bolts, two 3/8" x 1-1/4" hex bolts,
twelve 5/16" at washers and six 3/8" nylock nuts.
Tighten. See gure 7.
FIGURE 7
3/8" x 1-1/4"
HEX BOLT
3/8" x 3-1/4"
HEX BOLT
5/16" WASHER
5/16" WASHER
3/8" NYLOCK NUT