Instruction Manual

ASSEMBLY

This unit is shipped WITHOUT GASOLINE or OIL. After

assembly, see separate engine manual for proper fuel

and engine oil recommendations.

TOOLS REQUIRED FOR ASSEMBLY

(1) 1/2" Wrench

(2) 9/16" Wrenches

(2) 7/16" Wrenches

(1) Pliers

REMOVAL OF PARTS FROM CARTONS

1. Remove the hardware packs and all loose parts from

the cartons.

2. Lay out and identify parts shown in carton contents.

3. Lay out and identify parts in the hardware packs. Keep

contents of each hardware package separate.

5/16" NYLOCK NUTS

5/16" WASHERS

ASSEMBLING THE MOW-N-VAC

1. Tip the cart back to rest upright on the rear of the cart.

See gure 1.

2. Attach the wheel support to the cart using eight 5/16"

nylock nuts and 5/16" washers. See gure 1.

FIGURE 1

FIGURE 2

3. Attach the latch stand bracket (turned as shown)

using four 1/4" nylock nuts and two 1/4" washers.

Install the washers as shims underneath the latch

stand bracket, on the two rear studs. See gure 2.

(4) 1/4" NYLOCK NUTS

(2) 1/4" WASHERS

TAB

FIGURE 3

4. Install the rear tongue and the axle onto the cart body,

sliding the axle through the wheel support and the

tongue. Lock the tongue to the latch stand bracket

with the foot pedal latch. See gure 3.

IMPORTANT: Make sure the tongue is securely locked

to the latch stand bracket by the foot pedal latch.

AXLE

REAR TONGUE

FOOT PEDAL LATCH