User Manual

8
STEP 7: (SEE FIGURE 7)
• Attach the two push tubes (1) together using a clevis
pin (H) and a spacer (R) between the push tubes at
the end closest to the bulkhead (9).
• Insert a second clevis pin (H) through the opposite
side of the push tubes at the end furthest from the
bulkhead (9).
• Secure each clevis pin using a hair cotter pin (J).
Note: We recommend the two hair cotter pins (P) be on
opposite sides of the push tubes (1).
J
R
H
J
H
R
H
9
FIGURE 7
ASSEMBLE SQUARE TUBE TO BULKHEAD
STEP 8: (SEE FIGURE 8)
• Attach the square tube (13) to the bulkhead (9) using
two hex bolts (F), washers (X) and hex nuts (M).
• Insert the two square plugs (Z) into the square tube.
M
F
X
9
13
Z
FIGURE 8
ATTACH MOUNTING BRACKETS
STEP 9: (SEE FIGURE 9)
• Attach mounting brackets (11) to the square tube (13)
using two U-bolts (10).
• Secure the U-bolts with four washers (U) and four hex
nuts (P).
P
U
11
10
13
FIGURE 9