User Manual

7
ATTACH THE BULKHEAD TO THE BLADE
MOUNT ASSEMBLY
STEP 5: (SEE FIGURE 5)
• Insert the pivot shaft (8) through the two sets of pivot
brackets (5) of the blade mount assembly (7) and the
holes in the bulkhead (9).
NOTE: The holes to use in the bulkhead are determined
by your tractor height.
• Secure each end of the pivot shaft (8) using a
washer(Y) and a hair cotter pin (K).
8
9
5
7
K
Y
K
FIGURE 5
ATTACH PUSH TUBES TO THE BULKHEAD
STEP 6: (SEE FIGURE 6)
• With a push tube (1) level to the hitch mount assembly
(6), insert the uncapped end of the push tube into the
bulkhead (9) hole at that height.
• Repeat with the second push tube (1).
• Secure each push tube (1) to the bulkhead (9) using a
washer (Y) and hair cotter pin (K).
K
9
K
Y
Y
6
1
1
1
FIGURE 6