Use and Care Manual

7
11. (Figure 8) Assemble the height adjustment handle
totheinsideofthebracketontheendoftheheight
adjustmenttube.Usetwo5/16"x1"hexbolts(E),5/16"
atwashers(K)and5/16"nylocknuts(J).Tighten.
12. (Figure 8) Assemble the grip (W) onto the height
adjustmenthandle.
13. (Figure 9)Assembleontoa5/16"x1-1/4"hexbolt
(D)intheorderlisted,a5/16"atwasher(K),thepivot
bushing(S),theheightadjustmentstrapandthespacer
bushing(T).Inserttheboltthroughtheupperpartof
thedoubleholeintheendofthesweeperhousingand
secureitwitha5/16"nylocknut(J).Tighten.
5/16" NYLOCK NUT (J)
HEIGHT
ADJUSTMENT
HANDLE
GRIP (W)
5/16" FLAT WASHER (K)
5/16" x 1" HEX BOLT (E)
8
9
ENGLISH
14. (Figure 10) Place the star washer (L) between the
heightadjustmenthandleandtheheightadjustmenet
strap. Insert the 5/16" x1" carriage bolt (F) through
theheightadjustmenthandle,thestarwasherandthe
heightadjustmentstrap.Assemblea5/16"atwasher
(K)andtheplasticknob(X)ontotheendofthebolt.
5/16" FLAT
WASHER (K)
5/16" x 1"
CARRIAGE BOLT (F)
PLASTIC KNOB (X)
STAR WASHER (L)
(between strap and handle)
10
ASSEMBLY OF HOPPER BAG
1. (Figure 11) Fasten a rear frame tube (center holes
facingdown)tothetwoupperframetubesusingtwo
plastic plugs (Z).
11
PLASTIC
PLUG (Z)
UPPER FRAME
TUBES
REAR FRAME TUBE
HOLES FACE
DOWN
PLASTIC
PLUG (Z)
PIVOT BUSHING (S)
5/16" NYLOCK NUT (J)
SPACER BUSHING (T)
5/16" FLAT WASHER (K)
5/16" x 1-1/4"
HEX BOLT (D)
HEIGHT ADJUSTMENT
STRAP