Use and Care Manual

6
5/16" x 1-1/2"
CARRIAGE BOLT (C)
5/16" NYLOCK NUT (J)
5. Cutofftheplastictiethatholdstheheightadjustment
tubeinplace.
6. (Figure 4)AssembletheR.H.hitchtubetothesweeper
housingusingtwo5/16"x1-1/2"carriagebolts(C),and
two5/16"nylocknuts(J).Do not tighten yet. Repeat
fortheL.H.hitchtube.
7 (Figure 5)Fastenthehitchtubestogetherusingtwo
5/16"x2-1/2"hexbolts(A)and5/16"nylocknuts(J).
Do not tighten yet.
4
5
ENGLISH
5/16" x 2-1/2"
HEX BOLT (A)
5/16"
NYLOCK NUT (J)
If your tractor hitch has 10" to 13" ground clearance refer
to gure 6. If your tractor hitch has 8" to 10" ground
clearance refer to gure 7.
8. (Figure 6 or 7)Assemblethehitchbracketstothehitch
tubesusingtwo5/16"x2"hexbolts(B)and5/16"nylock
nuts(J).Theboltsshouldstraddlethefronthitchtube
bolt.Do not tighten yet.
9. Atthistimetightenthefourboltsfasteningthehitch
tubestothesweeperhousing.Next,tightenthetwobolts
fasteningtheendsofthehitchtubestogether.Finally,
tightenthetwoboltsfasteningthehitchbracketstothe
hitchtubes.
10. (Figure 6 or 7)Assemblethehitchpin(Y),two3/4"hitch
spacers(U)andthe1/8"haircotterpin(M)tothehitch
brackets.
5/16" x 2"
HEX BOLT (B)
5/16" NYLOCK
NUT (J)
3/4" SPACER (U)
HITCH PIN (Y)
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (M)
HITCH BRACKET
6
5/16" x 2"
HEX BOLT (B)
5/16" NYLOCK
NUT (J)
3/4" SPACER (U)
HITCH BRACKET
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (M)
HITCH PIN (Y)
7