Use and Care Manual

5
TOOLS REQUIRED FOR ASSEMBLY
(2)  7/16"OpenEndorBoxEndWrenches
(2)  1/2"OpenEndorBoxEndWrenches
ASSEMBLY
Allloosepartsareshownonpage2.Fastenersintheparts
bagareshownfullsizeonpage3.
Removethehardwarepackandallloosepartsfromthe
cartonandverifythatallthepartsandfastenersshownon
pages 2 and 3 are included.
ASSEMBLY OF SWEEPER
Note: Righthand(R.H.)andlefthand(L.H.)aredetermined
fromtheoperator'spositionwhileseatedonthetractor.
1. (Figure 1)Eachbrushassemblyhasonebrushretainer
markedwitheitherredorblackink.Layoutthebrush
assembliesasshownsothatthebrushretainersmarked
withinkareinthemiddlewiththeredoneontheright
andtheblackoneontheleft.
OVERLAP BRISTLES
BRUSH RETAINER
MARKED BLACK
BRUSH RETAINER
MARKED RED
IMPORTANT:Theoverlapbristlesatthebottomofeachbrush
helpsupportthebacksideofthebrushforbettersweeper
performance.Besurethesweeperisturnedasshownin
gures2and3tocorrectlyassemblethebrushes.
2. (Figure 2)Attachbrushassemblywithredbrushretainer
torightendofbrushshaftusingtwo1/4"x1"hexbolts
(G)and1/4"nylocknuts(I).Thebrushretainermarked
withredinkmustbeplacedtothemiddleofthesweeper.
BRUSH RETAINER
MARKED RED
OVERLAP
BRISTLES
1/4" x 1"
HEX BOLT (G)
1/4" NYLOCK NUT (I)
BRUSH RETAINER
MARKED RED
1
2
ENGLISH
3. (Figure 3) Attach brush assembly with black brush
retainertoleftendofbrushshaftusingtwo1/4"x1"
hexbolts(G)and1/4"nylocknuts(I).Thebrushretainer
markedwithblackinkmustbeplacedtothemiddle of
thesweeper.
4. (Figure 3)Turnawheeltorotatethebrushes.(Wheels
drivebrushesinonedirectiononly.)Theoverlapbristles
shouldbeonthebacksideofthebrushasitrotates.
1/4" x 1"
HEX BOLT (G)
1/4" NYLOCK NUT (I)
BRUSH RETAINER
MARKED BLACK
3