Use and Care Manual

10
15. (Figure 22)Securetheropetothetopcenterofthe
hopperbagframe.
16. (Figure 23)Toassemblethehopperbagtothesweeper,
slidetheendsofthebagarmtubesintotheendsofthe
sweeper'shitchtubesandsecurewithtwo1/4"x1-3/4"
clevispins(Q)and3/32"haircotterpins(N).
BAG ARM TUBE
1/4" x 1-3/4"
CLEVIS PIN (Q)
3/32" HAIR
COTTER PIN (N)
22
21
20
23
ENGLISH
IMPORTANT: Do notoverbendthesupportrodsduring
thefollowingstep.Overbendingwillcausethesteelrods
to loose supporting tension.
14. (Figure 21)Tipthehopperontoit'sbacktoassemble
thetwohoppersupportrods.Placetheendsofeach
rodintotheupperandlowerrearhoppertubes,bending
therodjustenoughtotintotheholesinthetubes.
SUPPORT
RODS
PALNUT (H)
13. (Figure 20)Assembletwopalnuts(H)lightlytapping
themontotheendsofthepivotrodwithahammer.