Product Manual

FIGURE 9

FIGURE 10

USING THE SMARTLINK PLATFORM

ATTACHING TOOLS - CENTER BRACE

Depending on which tool is used, the center brace

may need to be moved to either the center or top of the

Smartlink Platform.

ATTACHING TOOLS - LOADING TOOLS

Different tools should be attached in the ways outlined

below to lower risk of injury. Always exercise caution when

loading a tool into the platform.

PRE-ASSEMBLED BOLT

ROLLER AND DETHATCHER

SPIKE AND PLUG AERATOR

1. For roller and dethatcher tools, the center

brace should be attached to the top of the

Smartlink Platform as shown in gure 9. Tighten.

2. For spike and plug aerator tools, the center

brace should be attached to the middle of the

Smartlink Platform as shown in gure 10. Do not

tighten yet.

FIGURE 11

FIGURE 12

SPIKER/PLUGGER

1. Slide the bushings on each end of the tool into the

axle retainers one end at a time. Make sure the axle

retainers snap into the lock position. See gure 11.

2. Proceed to LOCKING TOOLS section on page 8.

ROLLER

1. Fill roller with water then insert and lock roller plug.

2. Position platform over roller.

3. Unlock lift handle and lower platform until axle

retainers lock onto bushings.

4. Proceed to LOCKING TOOLS section on page 8.

PRE-ASSEMBLED BOLT