Manual

ASSEMBLY iNSTRUCTiONS
TOOLS REQUIRED FOR ASSEMBLY
(1) Hammer
(!) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrenches
Lay out and identify parts and hardware using the
illustrations on pages 2 and 3.
STEP 1: (SEE FIGURE 1)
* insert a plug (AA) into the end of the hitch tube (9).
* Attach the hitch bracket (8) to the hitch tube using two
5/16" x 1-1/4" hex bolts (G) and 5/16" nylock nuts (I).
Tighten.
* install the hitch pin (A) in the hitch bracket and hitch
tube and secure it with the hairpin cotter (T).
A
AA
8
FIGURE
STEP 2: (SEE FIGURE 2)
* Attach the hitch support tubes (3), and (4) to the hitch
tube using one 1/4" x 2" hex bolt (C) and 1/4" nylock
nut (J). Do not tighten completely.
J
/
3
\
c
\
4
FIGURE 2
STEP 3: (SEE FIGURE 3)
* insert plugs (AA) into the ends of the hopper support
tubes (5) and (6).
o Attach hopper support tube (5) and hopper support
tube (6) to the hitch support tubes as shown, using
two 1/4" x 1-1/2" hex bolts (E) and 1/4" nylock nuts (J).
Do not tighten completely.
AA
/
/
AA
/ 0
J
/
?
E
FIGURE 3
STEP 4: (SEE FIGURE4)
• insert the bushing (Y) into the cross brace (7).
• Attach the cross brace to the hopper support tubes
using two 1/4" x 2-1/2" hex bolts (B) and 1/4" nylock
nuts (J). Do not tighten completely.
B
FIGURE 4