User Manual

STEP 5: (SEE FIGURE 5)

• Insert plugs (S) into the ends of the hopper support

tubes (5) and (6).

FIGURE 5

STEP 6: (SEE FIGURE 6)

• Slide the spreader impeller (12) onto the spreader

shaft and secure it with a 1/8" x 1-1/2" cotter pin (Q).

FIGURE 6

STEP 7: (SEE FIGURE 7)

• Place the hopper on the hopper support tubes,

inserting the spreader shaft up through the square

hole in the bottom of the hopper.

• Slide the hopper bushing (X) onto the spreader shaft

and insert it into the bottom of the hopper.

• Slide the spacer (K) onto the spreader shaft.

• Install the agitator hairpin (I) in the spreader shaft.

FIGURE 7

FIGURE 8

STEP 8: (SEE FIGURE 8)

• Attach the hopper to the upper set of holes in the

hopper support tubes using four 1/4" x 1-3/4" hex bolts

(D), 1/4" washers (M), nylon washers (N) and 1/4"

nylock nuts (J). Make only nger tight.

• Insert the 1/4" x 1" hex bolt (F) into the hole in the

bottom of the hopper, pressing the head of the bolt

into the hex shaped recess of the hole. Install a 1/4"

nylock nut (J) onto the bolt and tighten.