Instructions / Assembly

6
FIGURE 10
FIGURE 9
FIGURE 8
22. Insert the 5/16" x 1-3/4" carriage bolt up through the slot
and secure it with a nylon washer and the plastic wing
nut.Seegure9.
23. Move the lift handle into the locked position as shown
ingure9andthentipthespreaderbacktorestonthe
wheels and the rear of the hopper.
(K) 1/4" NYLOCK
HEX NUT
CENTER
BRACE
(G) 1/4" x 1-1/4"
HEX BOLT
(K) 1/4" NYLOCK
HEX NUT
(O) 1/4" FLAT
WASHER
(O) 1/4" FLAT
WASHER
(H) 1/4" x 3/4"
HEX BOLT
(K) 1/4" NYLOCK
HEX NUT
(GG) PLASTIC WING NUT
(P) NYLON
WASHER
(I) 5/16" x 1-3/4"
CARRIAGE BOLT
LOCKED POSITION
19.Placetheowcontrolleverintotheslotinthehopper.
Seegure8.
20. Place the center brace into the hopper. Insert the 1/4" x
1-1/4" hex bolt through the center brace and the front of
thehopper.Assemblea1/4"atwasher,theowcontrol
lever and a 1/4" nylock hex nut onto the bolt. Do not
tighten yet.Seegure8.
21. Insert the 1/4" x 3/4" hex bolt through the center brace
andtherearofthehopper.Assemblea1/4"atwasher
and 1/4" nylock hex nut onto the bolt. Tighten both the
frontandrearbolts.Seegure8.
FLOW
CONTROL
LEVER
FEED PLATE
(P) NYLON
WASHER
(K) 1/4" NYLOCK
HEX NUT
(K) 1/4" NYLOCK
HEX NUT
(K) 1/4" NYLOCK
HEX NUT
(U) 3/32" x 3/4"
COTTER PIN
(CC) FLOW
CONTROL LINK
(II) EXTENSION
SPRING
24.Movetheowcontrolleverasfarasitwillgotothe"OFF"
position. Push the feed plate back as far as it will go to
theclosedposition.Seegure10.
25.Placeanylonwasherontothebentendoftheowcontrol
link and then insert the link into the feed plate bracket.
Secureitwitha3/32"x3/4"cotterpin.Seegure10.
26. Tighten the lower 1/4" nylock hex nut until it touches the
bottom of the ferrule, then tighten the upper 1/4" nylock
hex nut until it is snug against the top of the ferrule. See
gure10.
27. Hook the open end of the spring into the feed plate.
Place the closed end of the spring onto the end of the
hexboltintheowcontrollever.Secureitwitha1/4"
nylockhexnut.Seegure10.
28.Openandclosethefeedplateusingtheowcontrollever.
Check to make sure the feed plate is closed completely
when the lever is in the "OFF" position. If the feed plate
does not close completely, adjust the 1/4" nylock hex
nutsontheowcontrollink.Seegure10.
ENGLISH