User Manual

ManualsBrandsAgri-Fab ManualsOutdoors10 cu. ft. Steel Dump Cart

Figure 10

Figure 9

Figure 11

STEP 9 (SEE FIGURE 9): Attach the latch stand

bracket (9) to the cart bed and front panel (8)

using four 1/4" hex bolts (E) and 1/4" nylock nuts

(F). Make sure to orient the tab on the latch stand

bracket as shown in gure 9.

Figure 12

Figure 13

STEP 10 (SEE FIGURE 10): Position the cart bed

upside down and place the draw bar tongue (4) as

shown in gure 10.

STEP 11 (SEE FIGURE 11): Install the axle (11)

through the wheel support, a spacer (O), the draw

bar tongue (14), a spacer (O), and the wheel

support as shown in gure 16.

Figure 14

Figure 15

STEP 12 (SEE FIGURE 12): Attach the wheels to

the axle by installing a large washer (H), a wheel

(12), another large washer (H) and a 1/8" cotter pin

(J). Repeat this step for the other side.

Note: Be sure to lubricate the axle ends before

attaching wheels.

STEP 13 (SEE FIGURE 13): Install the latch lock

lever (13) by inserting a 5/16" x 3" hex bolt (A)

through one side of the draw bar tongue (14), a

spacer (B), the latch lock lever (13) a spacer (B),

the other side of the draw bar tongue (14), and a

5/16" nylock nut (G) as shown in gure 13.

STEP 14 (SEE FIGURE 14):

Attach the extension

spring (I) to the latch lock lever by inserting one

end into the hole in the latch lock lever. Using the

spring puller tool (K), attach the other end of the

extension spring (I) to the square hole in the draw

bar tongue as shown in gure 14.

STEP 15 (SEE FIGURE 15): Attach the hitch

bracket (3) to the draw bar tongue using two 5/16"

x 3/4" truss head bolts (D) and 5/16" nylock nuts

(G). Install the hitch pin (L) through the holes in

the hitch bracket (L) and the draw bar tongue and

secure with a 1/8" hair cotter pin (M).

Quick Start Guide

45-03037 Steel Cart

Read the manual that came with your Steel Cart for:

• Important safety warnings

• Further explanation of features

• Operating instructions

Problem?

Call 1-800-448-9282