Use and Care Manual

6
IMPORTANT:Makesurethetrayisturnedsothatthe
lockingnotchisatthefrontasshowningure8.
11. Assemblethetonguetothetrayusingtwo3/8"x1"
hexbolts(D),two3/8"x1-1/4"hexbolts(C),four
1/4"longspacers(P),andfour3/8"nylocknuts(J)as
showningure8.Tighten.
12. Assembletwo3/8"x1-1/4"hexbolts(C),four1/4"
longspacers(P)andtwo3/8"nylocknuts(J)tothe
holesontheothersideoftheslotinthetray.Tighten.
Seegure8.
FIGURE 10
FIGURE 8
FIGURE 9
15. Fastentheendplatestothecornersofthetrayusing
eight5/16"x3/4"hexbolts(E)and5/16"nylocknuts
(K). Do not tighten till step 18.
5/16" x 3/4"
HEX BOLT (E)
(Temporary)
3/8" x 1"
HEX BOLT (D)
MIDDLE
BRACE
3/8" NYLOCK NUT (J)
3/8" x 1"
HEX BOLT (D)
3/8" x 1-1/4"
HEX BOLT (C)
3/8" x 1-1/4"
HEX BOLT (C)
1/4" LONG
SPACER (P)
3/8" NYLOCK NUT (J)
LOCKING
NOTCH
13. Placethetraybetweentheendplates.Temporarily
insertone5/16"x3/4"hexbolt(E)intoeachback
cornerandoneofthefrontcornersofthetrayto
holdendplatestogetheratthreeofthefourcorners.
14. Rotatethemiddlebraceupagainstthetongue,
aligningitonthesideofthetonguethatisnextto
theslotinthetray.Fastenthebracetothetongue
usingtwo3/8"x1"hexbolts(D)and3/8"nylock
nuts(J).Do not tighten till step 18.
5/16" x 3/4"
HEX BOLT (E)
5/16" NYLOCK
NUT (K)
ENGLISH