Use and Care Manual

4
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(2) 7/16"wrenches
(2) 1/2"wrenches
(2) 9/16"wrenches
(2) 3/4"wrenchesoradjustablewrenches
Beforeassemblingtheaerator,layoutalltheparts
andhardwareasshownonpreviouspages.
CAUTION: pointsofaeratorknivesare
sharp!Exercisecautionatalltimeswhile
assemblingandusingtheaerator.
3. Assembleawheelbrackettothemiddleholeinthe
shaftsothatthehubofthebracketfacestheshort
endoftheshaft.Fastenthebrackettotheshaftusing
a1/4"x1-3/4"hexbolt(B)anda1/4"nylocknut(L).
Tighten.Seegure2.
4. Pre-assemblea3/8"x1-1/4"hexbolt(C)anda3/8"
nylocknut(J)tothesmallerholeinthewheelbracket.
Inserttheboltfromthehubsideofthebracket.Do
not tighten till step 18.Seegure2.
FIGURE 2
FIGURE 1
FIGURE 3
5. Assembleaspoolassembly,a5.29"longspacer(U),
anotherspoolassembly,a1.00"longspacer(S)and
a3/4"atwasher(O)ontotheshort endoftheshaft.
Seegure3.
1/4" x 1-3/4"
HEX BOLT (B)
1/4"
NYLOCK NUT (L)
3/8"
NYLOCK NUT (J)
3/8" x 1-1/4"
HEX BOLT (C)
SHORT END
OF SHAFT
5.29" LONG
SPACER (U)
1.00" LONG
SPACER (S)
3/4" FLAT
WASHER (O)
SHORT END
1. Assembleeightaeratorknivesontheoutside of
eachdoublespoolassembly.Rotateeachknifeto
insertthelockingtabintothespoolplate,thenalign
thesquareholesandsecurewitha5/16"x3/4"
carriagebolt(F), a5/16"lockwasher(N),anda5/16"
nylocknut(K).Seegure1.
2. Pushsplitplasticbearings(X)intobothendsofall
spoolassemblies.Seegure1.
5/16" x 3/4"
CARRIAGE BOLT (F)
5/16" LOCK
WASHER (N)
5/16"
NYLOCK NUT (K)
SPLIT
BEARING (X)
SPLIT
BEARING (X)
ENGLISH