Product Manual

5
6. Assemblea2.38"longspacer(S),a3/4"atwasher
(O),themiddlebrace,a3/4"atwasher(O)anda
3.90"longspacer(Q)ontothelong endoftheshaft.
Thebentlipofthemiddlebracemustfacetheshort
endoftheshaft.Nextassembleaspoolassembly,
a5.29"longspacer(T),anotherspoolassembly,a
1.00"longspacer(R)anda3/4"atwasher(O)onto
theshaft.Seegure4.
FIGURE 5
FIGURE 6
8. Assembleawheeltoawheelbracketusinga1/2"x
3-1/2"hexbolt(A),two1/2"washers(P),a1/2"jam
nut(M)anda1/2"nylockjamnut(I).Adjustthenuts
sothatthewheelisheldsecurelybutwillspinfreely.
Repeatonotherside.Seegure6.
FIGURE 7
9. Assemblethehitchbrackettothetongueusing
two3/8"x1"hexbolts(D)and3/8"nylocknuts(J).
Tighten.Seegure7.
10. Assemblethehitchpin(G)throughthehitchbracket
andthetongue.Secureitwiththehaircotterpin(H).
Seegure7.
7. Rotatethewheelbracketfastenedtothemiddleof
theshaftsothatitispointingupward.Assemblean
endplate,a3/4"atwasher(O)andasecondwheel
bracketontothelong endoftheshaft.Pointthis
wheelbracketasshowningure5.Secureittothe
shaftusinga1/4"x1-3/4"hexbolt(B)and1/4"nylock
nut (L). Tighten.Repeatonshortendofshaft.
FIGURE 4
3/8" NYLOCK NUT (J)
3/8" x 1"
HEX BOLT (D)
HAIR COTTER PIN (H)
HITCH
PIN (G)
1/4" x 1-3/4"
HEX BOLT (B)
1/4" NYLOCK NUT (L)
3/4" FLAT WASHER (O)
MIDDLE WHEEL BRACKET
POINTING UP
1/2" NYLOCK
JAM NUT (I)
1/2" x 3-1/2"
HEX BOLT (A)
1/2"JAM NUT (M)
1/2" WASHER (P)
1/2" WASHER (P)
2.38" LONG
SPACER (S)
1.00" LONG
SPACER (R)
3/4" FLAT
WASHER (O)
MIDDLE
BRACE
3.90" LONG
SPACER (Q)
3/4" FLAT
WASHER (O)
LONG END
OF SHAFT
5.29" LONG
SPACER (T)
ENGLISH