Instructions / Assembly

6
18. Attach the sprayer to the tractor hitch and connect the
wiring to the tractor battery. The red wire must be
connected to the positive post on the battery or to the
"HOT" connection on a tractor switch or ammeter. The
brown wire may be grounded or connected to the
negative battery post. See figures 11 and 12.
IMPORTANT: This sprayer should be connected to 12
volt batteries only!
BROWN
PUMP SWITCH
RED
QUICK COUPLER
BATTERY
+
RED
BROWN
14. Insert a garden hose gasket into the swivel nut on
the bypass/return hose. Screw the nut onto the
upper outlet of the "Y" valve fitting. Place the other
end of the hose down through the hole at the rear
of the tank. See figure 10.
15. Insert a garden hose gasket into the swivel nut on
the boom connecting hose. Screw the nut onto the
lower outlet of the "Y" valve fitting. See figure 10.
16. Slide the 1/4" hose clamp onto the spray gun
hose. Push the hose onto the hose adapter on the
side of the "T" fitting as shown in figure 10. Tighten
the clamp around the hose and the adapter. Wrap
the hose around the tank and snap the spray gun
into the clips on the side of the tank.
17. Carefully screw the pressure gauge into the top of
the "T" fitting. See figure 10.
FIGURE 9
FIGURE 10
13. Assemble the large and small spray gun clips to
the side of the tank using two #10 x 1/2" screws
and #10 lock washers. See figure 9.
NEVER ALLOW NEGATIVE PIN ON
PLUG TO COME IN CONTACT WITH
POSITIVE "HOT" POST ON BATTERY.
FIRE OR EXPLOSION MAY RESULT!
PLUG
NEGATIVE PIN
12 VOLT TRACTOR BATTERY
POSITIVE
"HOT"
POST
+
NEGATIVE
POST
FIGURE 12
FIGURE 11
SPRAY GUN
CLIP (LARGE)
SPRAY GUN
CLIP (SMALL)
#10 x 1/2"
SCREW
#10 LOCK
WASHER
BOOM CONNECTING HOSE
SPRAY
GUN
HOSE
PRESSURE
GAUGE
1/4" HOSE
CLAMP
BYPASS/RETURN HOSE
GARDEN
HOSE
GASKET