Instructions / Assembly

5
11. Install the drain in the bottom of the tank as shown
in figure 7. Place a 3/4" garden hose gasket onto
the drain body and insert the drain body down
through the hole in bottom of the tank. Outside the
tank, assemble the nylon washer and then the
nylon nut onto the drain body. Tighten the nut
securely enough to prevent leaking, being careful
not to damage the plastic parts. Place the O-ring
inside the nylon cap and screw the cap onto the
end of the drain body.
FIGURE 8
7. Slide the axle through the two axle brackets. See
figure 5.
8. Assemble a spacer, a 1/2" washer, a wheel (valve
stem facing out) and another 1/2" washer onto the
axle. Assemble a 1/8" x 1-1/2" cotter pin to the end
of the axle. Repeat on other end. See figure 5.
9. Assemble the boom mount bracket to the rear of
the hitch tubes using two 5/16" x 1-3/4" carriage
bolts, 5/16" lock washers and 5/16" hex nuts. Do
not tighten yet. See figure 6.
5/16" LOCK
WASHER
5/16" HEX NUT
5/16" x 1-3/4"
CARRIAGE BOLT
FIGURE 6 REAR VIEW
10. Tighten the four bolts which fasten the hitch tubes
to the bottom of the tank. See figure 2.
Tighten the four hex nuts which fasten the axle
brackets to the hitch tubes. See figure 1.
Tighten the two bolts which fasten the front of the
hitch tubes together. See figure 3.
Tighten the two bolts which fasten the hitch brack-
ets to the hitch tubes. See figure 4.
Tighten the two bolts which fasten the boom
mount bracket to the rear of the hitch tubes. See
figure 6.
3/4" WASHER
SPACER
1/8" x 1-1/2"
COTTER PIN
FIGURE 5
12. Assemble the boom bars to the boom mount
bracket using two 5/16" x 1-1/4" carriage bolts,
tooth lock washers (between the bar and bracket),
5/16" flat washers and knobs. The boom connect-
ing hose should extend upward. See figure 8.
NOTE: Make sure the nozzles are adjusted so that
the openings face straight down when the boom
bar is in the horizontal operating position.
FIGURE 7 REAR VIEW
DRAIN BODY
HOSE GASKET
NYLON WASHER
NYLON NUT
O-RING
NYLON CAP
CARRIAGE BOLT
5/16" x 1-1/4"
KNOB
5/16" FLAT
WASHER
WASHER
(TOOTH LOCK)
BOOM BAR

BOOM CONNECTING HOSE