Owners manual

4
3. Now tighten the four bolts from step 1.
4. Assemble a bag rod clip to the inside of each lower
handle tube using a hex bolt secured down against the
clip with a 1/4" nylock nut. The clips should face towards
thesweeperhousing.Seegure3.
HEX BOLT
1/4" NYLOCK NUT
5. Slide the long bag rod (28-1/2" long) through the stitched
bagaponthetopofthehopperbagasshowningure
4.
6. Slide the short bag rod (25-1/2" long) through the stitched
bagaponthebottomofthehopperbagasshownin
gure4.
7. Assemble the two plastic rod caps to the rod ends of
the bottom bag rod. Assemble two Palnuts to the ends
ofthetopbagrod.Seegure5.
8. Assemble the two plastic caps 3/4" x 7/8" onto the ends
ofthelegstandsasshowningure6.
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6