Owners manual

3
HARDWARE PACK (NOT SHOWN FULL SIZE)
A
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1) Phillips Screwdriver
(1) Adjustable Wrench
(1) 7/16" Open End or Box Wrench
1. Assemble the two Handle Leg Stand Tubes to the
Sweeper Housing, using two hex bolts 1/4-20 x 1-1/4"
long,atwashersand1/4-20nylocknuts,perhandle.
Seegure1.Onlyhandtightenatthistime.
1/4"
NYLOCK
NUT
2. Assemble the Upper Handle Tube over the Handle Leg
StandTubes.Seegure2.Alignholesinhandleand
assemble the Bag Rod Clips to the handle as shown
and fasten with hex bolts and nylock nuts.
HEX BOLT
1/4" NYLOCK NUT
FIGURE 1
FIGURE 2
Ref. Description Qty.
No.
A Hex Bolt, 1/4-20 x 1-1/4" 8
B Flat Washers 1/4" I.D. 4
C Nylock Nuts 1/4-20 8
D Bag Rod Clips 4
F Palnut 1/4" 2
G Plastic Caps (for bag rods) 2
H Plastic Caps (for leg stands) 2