User Manual

6
ADDITIONAL SAFETY RULES
WARNING: Never operate a damaged machine. Always tag a damaged machine and take it out of
service until repairs can be made.
WARNING: Do not attempt to groove or rabbet (rebate) with this machine. This machine is for cutting
only.
The arbor size of wheels and flanges must properly fit the spindle of the power tool. Wheels and
flanges with arbor holes that do not match the mounting hardware of the power tool will run out of
balance, vibrate excessively and may cause loss of control.
• Replacethetablewhenworn.
• Wearsuitableprotectiveclothingandequipment;includingbutnotlimitedto:eyeprotection,hearing
protection and anti-slip footwear
• Weargloveswhenhandlingsawblades,butdonotoperatethemachinewearinggloves
• Neveruseguardsfortransportingorhandlingthemachine.Transportandcarrythemachineonlybythe
carry handle.
• Covertheupperpartofthesawbladeatalltimeswhiletransporting
• Supportlongworkpiecestominimisetheriskofbladepinchingandkickback.Largepanelstendtosag
under their own weight. Supports must be placed under the panel on both sides, near the line of cut and
near the edge of the panel.
INTRODUCTION
This machine is designed for water cooled cutting of tile materials. The motor is single phase induction type.
It has an integrated partial immersion water cooling system as required for diamond cutting. It must only be
used with a diamond blade. It is intended for cutting tiles made of natural stone, ceramic porcelain, and similar
materials. All other uses are prohibited.
LIST OF CONTENTS
1. Tile Saw
2. M19 combination wrench
3. M8 combination wrench
4. Parallel cutting guide
5. Angle guide plate
6. Diamond blade
ASSEMBLY
Mount the blade. ( See below “Mounting the Blade”)