User Manual

11
MAINTENANCE AND CLEANING
The slurry created by the wet cutting process must be rinsed off. Remove the table, water tray, blade guard and
shroud, then rinse them clean with a hose.
Wipe other areas clean.
Daily Maintenance
• Keepthemachineclean
• Checktoensurethatthepowersupplycableisingoodcondition.
• Ensureallscrews,nutsandfastenersaretight.
• Checktheconditionofallsafetyequipmentsuchasthebladeguard
• Checkthebladefordamage.
Model Power Level Pressure Level Vibration Level
Lwa(dB)ISO 3744 Lpa(dB) ISO4871 G en NF ENV 25349
0.75KW240V 76 63 0.09
0.75KW115V 74 65 0.07
If the replacement of the power supply cord is necessary, this has to be done by the manufacturer or their
agent in order to avoid a safety hazard.
WARNING: All repairs must be entrusted to an authorized service center. Incorrectly performed repairs
could lead to injury or death.
Do not throw electric power tools into the household waste!
In accordance with the European Directive 2002/96/EG on Waste Electrical and Electronic Equipment and
transposition into national law, used electric power tools must be collected separately and recycled in an
environmentally friendly manner.