User Manual

10
BEVEL CUTS
The motor assembly may be tilted up to 45 degrees for performing
bevel cuts. To adjust the bevel angle, loosen the two hand knobs
on the right and left sides of the machine, adjust to the desired
angle, and then retighten the knobs.
OPERATION
Before cutting
• Ensurethattheoperatingenvironmentisfreeorclutter
• Fillthewatertray
• Refertothescaleonthetableandsetthecuttingguidetothedesiredwidthofcut
• Adjustthebladeguardtobeascloseaspossibletotheworkpiece
• Ensurethatallbystandersareatasafedistance.
• Ensurethattheequipmentisgrounded.
• Ensurethatallsafetyequipmentisinplace.
CAUTION: Never cut dry and do not allow the water tray to run dry. Blade life will be severely shortened.
CUTTING TECHNIQUE
• StartthemachinebypressingthegreenONbutton
• Allowthemotortoreachfullspeed,thenholdthetilefirmly,andsteadilyfeedthetiletotheblade
• Donotallowthemachinetobogdown.Limityourfeedpressuretokeepthebladespinningathigh
speed.
• Donotpushtoohardattheendofthecut.
• Keepyourhandsawayfromtheblade
STOPPING
Press the red OFF button to stop the machine. After the motor is
shut off, the blade will continue spinning for a time.
WARNING: Keep hands and objects away from the blade while
it is still spinning.
Bevel angle knob
switch