User Manual

9
involved .
MOTOR AND ELECTRICAL
REQUIREMENTS
WARNING: To reduce the risk of electrical
hazards, fire hazards or damage to the tool, use
proper circuit protection. To reduce the risk of
shock or fire, if the power cord is worn or cut, or
damaged in any way, have it replaced
immediately.
ELECTRICAL CONNECTIONS
NOTE: The plug supplied on your tool may not fit
into the outlet you are planning to use. Your local
electrical code may require slightly different power
cord plug connections. If these differences exist
refer to and make the proper adjustments per your
local code before your tool is plugged in and
turned on. In the event of a malfunction or
breakdown, grounding provides a path of least
resistance for electric current to reduce the risk of
electric shock. This tool is equipped with an
electric cord that has equipment grounding
conductor and a grounding plug. The plug must be
plugged into a matching outlet that is properly
installed and grounded in accordance with all local
codes and ordinances. Do not modify the plug
provided. If it will not fit the outlet, have the proper
outlet installed by a qualified electrician.
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. The
conductor with insulation has an outer surface that
is green with or without yellow stripes is the
equipment-grounding conductor. If repair or
replacement of the electric cord or plug is
necessary, do not connect the equipment-
grounding conductor to a live terminal.
If the power cord is worn or cut, or damaged in any
way, have it replaced immediately by a qualified
electrician. If the grounding instructions are not
completely understood, or if you are in doubt as to
whether the tool is properly grounded check with
a qualified electrician or service personnel.
WARNING: Do not permit fingers to touch the
terminals of plug when installing or removing
the plug from the outlet to avoid injury or
possible death from electrical shock.
WARNING: If not properly grounded, this tool
can cause an electrical shock, particularly when
used in damp locations, in proximity to
plumbing, or outdoors. If an electrical shock
occurs there is the potential of a secondary
hazard, such as your hands contacting the
milling head.
MOTOR SAFETY PROTECTION
IMPORTANT: To avoid motor damage, this
motor should be blown out or vacuumed
frequently to keep dust from interfering with
normal motor ventilation.
1. Connect this tool to a power source with the
appropriate voltage for your model.
2. If the motor won’t start, turn the switch “OFF”
immediately and unplug the tool.
3. If the motor suddenly stalls while milling,
release the trigger switch and unplug the
tool. The motor may now be restarted.
4. Fuses may "blow" or circuit breakers may trip
frequently for the following reasons:
a. Motor Is Overloaded - Overloading can
occur if you make too many start/stops in
a short time.
b. Line voltages should not be more than
10% above or below the nameplate
voltage. For heavy loads, however, the
voltage at motor terminals must equal
the voltage specified for your model.
Improper or dull milling head is being
used.
5. Most motor troubles may be traced to loose
or incorrect connections, overload, low