User Manual

14
KEEPING TOOL CLEAN
Keep the machine and air inlet louver clean at all
times to ensure correct and safe working. Under
extreme application conditions involving metal,
dust can enter the interior of the machine. The
protective insulation of the machine can be
adversely affected. In such cases the machine
should be blown out regularly though the air inlet
louver. It is recommended that a vacuum
attachment be used.
WARNING: To ensure safety and reliability, all
repairs, with the exception of externally
accessible brushes, should be performed at an
Authorized Service Center.
WARNING: If the replacement of the power
supply cord is necessary, this has to be done
by the manufacturer or their agent in order
to avoid a safety hazard.
Do not throw electric power tools into the
household waste! In accordance with the European
Directive 2002/96/EG on Waste Electrical and
Electronic Equipment and transposition into
national law, used electric power tools must be
collected separately and recycled in an
environmentally friendly manner.
OPTIONAL FLOOR GRINDING TROLLEY
This machine has built-in mounting tabs in its handle for mounting to
the optional floor grinding trolley for fatique free grinding of floors.
The trolley's 4 spring-loaded mounting plungers thread into the tabs
to suspend the machine.
To keep the switch locked on, first ensure that the tool is unplugged.
With the trigger switch on, wrap the hook and loop strap around the
switch. Plug the tool into the socket on the trolley. Then use the
switch on the trolley to turn the tool on and off.
CAUTION:
Do not attempt edge grinding with the machine mounted to the floor grinding trolley. The extra
leverage of the trolley will easily damage the sanding plate cover dust skirt when it inevitably contacts
the wall. In addition, the range of motion allowed by the floor grinding trolley is not suitable for edge
grinding. Always perform edge grinding in hand-held mode only. Only use the floor grinding trolley for
open areas
.