User Manual

12
To attach vacuum hose to Dust Port,hold machine
firmly with one hand. Then with a twisting motion
push the vacuum hose onto the Dust Port.
SAFETY GUARD
The Safety Guard (ie. the Skirt) must be used at all
times when operating this machine. It is not
adjustable. The Half-Moon Door may be
temporarily removed to expose the Edge Cut-Out.
See below.
THE EDGE CUT-OUT
When working against a wall or into a corner, the
Skirt will prevent the grinding head from reaching
all the way to the edge. In this case, one may
remove the Half-Moon Door by pushing inward on
the two clips. The Half-Moon Door may be
temporarily adhered to the handle crossbar using
its magnet. This will expose the Edge Cut-Out in
the skirt. This will allow the Grinding Head reach
right up to the edge. Dust collection will not be
ideal so replace the door as so replace it as soon as
access to the Edge Cut-Out is no longer needed.
TOOL CHANGE – Removing and
Replacing Diamond Cup Wheel
CAUTION: Before Working on or adjusting the
machine, switch the machine “OFF” and
UNPLUG machine from the socket.
CAUTION: The wheel can become very hot
during the working process. Before replacing,
allow the wheel to cool down
1. Place the machine on a level and sturdy
workspace.
2. If using a diamond cup wheel with M14
female thread, do not use the flanges. Simply
thread the wheel onto the spindle. Use the
L-Hex Wrench to keep the spindle from
turning and tighten the wheel using the Face
Spanner Wrench.
3. If using a diamond cup wheel with 7/8"
(22.23mm) arbor hole, first thread the Inner
Flange onto the spindle. Mount the wheel
onto the shoulder of the Inner Flange, then
thread on the Arbor Nut. Use the L-Hex
Wrench to keep the spindle from turning and
tighten the Arbor Nut with the Lock Nut
Wrench.
4. Removal is the reverse of the above.
INSTALLING DIAMOND CUP WHEELS
W/ M14 FEMALE THREAD.
Dust Port
Face Spanner Wrench
L-Hex Wrench
Edge Cut-Out in Skirt
Clips
Half-Moon Door
Magnet