User Manual

10
voltage, (such as small size wire in the supply
circuit) or to an overly long supply circuit
wire. Always check the connections, the load
and the supply circuit whenever motor
doesn’t work well. Check wire sizes and
length with the Wire Size Chart.
WIRE SIZES
NOTE: Make sure the proper extension cord is used
and is in good condition. . The use of any extension
cord will cause some loss of power. To keep this to
a minimum and to prevent overheating and motor
burnout, use the table on Page 8 to determine the
minimum wire size (A.W.G.) extension cord.
UNPACKING
WARNING: To reduce the risk of injury from
unexpected starting or electrical shock, do not
plug the power cord into a power source outlet
during unpacking and assembly. The cord must
remain unplugged whenever you are working
on the tool.
Your tool is shipped complete in one box.
Remove the tool and all loose parts from the
carton.
Place all parts on a secure, stationary work surface
and look the machine over carefully.
LIST OF PARTS
NOTE: Before beginning assembly, check that all
parts are included. If you are missing any part(s),
do not assemble the machine. Sometimes small
parts can get lost in packaging material. Do not
throw away any packaging until tool is put
together. Check packaging for missing part(s). A
complete parts list (Repair Parts) is at the end of
the manual. Use the list to identify the number of
the missing part(s).
WARNING: If any parts are missing do not
operate your Power Scouring Machine until the
missing parts are replaced. Failure to do so
could result in possible serious injury.
List of Contents
Basic Assembly..................................1
Operator’s Manual........................... 1
Side Handle........................................ 1
Lock Nut Wrench...............................1
Face Spanner Wrench .....................1
L-Hex Wrench......................................1
Flanges..................................................2
RECOMMENDED ACCESSORIES
This machine may only be used with diamond cup
wheels of 180mm diameter with 22.23mm (7/8")
arbor hole or with M14 female thread. All other
uses are prohibited.
Bonded abrasive accessories are not allowed to be
used with this machine.
BASIC OPERATION
NOTE: Make sure that the power circuit voltage
is the same as that shown on the specification
plate of the machine and that switch is “OFF”
before connecting the tool to the power circuit.
Total Extension
Cord Size (AWG)
Cord Length (feet)
25 16
50 12
100 10
150 8
200 6