User Manual

9
Finally, carefully work the vacuum hose free then lift
sanding plate cover away.
Replacement is the opposite of removal. Don’t
forget the spring. Entrust all repairs to an
authorized service center.
To install the vacuum cleaner hose
1. Unplug the machine.
2. Plug the vacuum cleaner hose bayonet mount
into the swivel mount in the back of the
machine. Once the tangs of the bayonet mount
are fully inserted in the slots, hold the swivel
mount from turning and turn the hose bayonet
mount clockwise to lock.
3. Removal is the opposite of assembly.
The vacuum cleaner:
Ensure that you have a bag installed in your vacuum
cleaner which is approved and rated for drywall
dust.
WARNING: Failure to use an approved dust bag in
your vacuum will increase the level of airborne
dust in the work area. Prolonged exposure to
such dust may cause respiratory harm.
STARTING AND STOPPING TOOL
Make sure that the power circuit voltage is the same
as that shown on the specification plate of the
machine and that switch is “OFF” before connecting
the tool to the power circuit.
Switching the machine on and off
To switch on:
While holding with the left hand on the column and
the right hand on the main handle, Press the rocker
switch to the right with the thumb of the right hand.
Anticipate and be ready for the start up torque when
the machine first starts.
To switch off:
Press the rocker switch to the left. After the machine
has been switched off, the sanding disc will still
rotate for a time. Take care that parts of your body
do not come into contact with the disc and do not
set the machine down while it is still rotating!
Adjusting the rotation speed:
The speed of the machine is variable to suit different
tasks. It can be adjusted from 650/min up to 1600/
min by using the thumb wheel. Using the right
On/Off Switch