User's Manual

RATTLER TS USER MANUAL 19
2.2.9 RETICLE COLOR
You can change the color of the crosshairs.
Enable reticle first.
1. Hold
button to show the menu.
2. Select
Color menu item and press button to switch the color of
crosshair. White, Green, and Red colors are selectable.
3. Hold
button to save and exit.
2.2.10 TRAJECTORY CORRECTING
Enable the trajectory correction to shot the target with high accuracy by
marking the offset between the big crosshair and small crosshair.
Select the desired reticle type in the Boresighting menu.
1. Hold
button to show the menu.
2. Select
Trajectory menu item. Two crosshairs show in the view. The big one
is reticle crosshair, and the small one is trajectory correction crosshair.
3. Set the distance.
1). Press
button, and then press or buttons to adjust the
distance between the target and the device.
2). Press
button to save the distance settings.
4. Set the crosshair position of trajectory correction.
1) Aim the big crosshair at the target.
2) Shot and mark the actual drop point of the bullet.
3) Press
, , and buttons to move the small cursor to the
position of the actual drop point. You can view the coordinate of the cursor
in the view.
5. Press
button to switch to the next distance.
6. Repeat step 3 to 4 to set another trajectory correction position.
You can save up to five corrections for different distances. Corrective aiming
points will be displayed with short lines on the reticle.
7. Hold
button to exit.
FIGURE 2-8. TRAJECTORY CORRECTING