User's Manual

AGM Global Vision18
2.2.7 PICTURE IN PICTURE MODE
1. Hold button to show the menu.
2. Select
PIP menu item and enter PIP mode. The details show in the upper
left corner.
NOTE:
When Boresighting is enabled, the PIP view is the detail of crosshair.
When Boresighting is not enabled, the PIP view is the detail of central part.
3. Press
button to switch the PIP type. Upper Left, Upper Middle, Upper
Right, and OFF are selectable.
NOTE:
When you select Upper Right as PIP type, the OSD will be blocked.
4. Hold
button to exit.
If digital zoom is enabled, the PIP view also zooms. If the digital zoom ratio
exceeds 4, the PIP does not zoom.
2.2.8 BORESIGHTING
Enable the reticle to aim at the target.
1. Hold
button to show the menu.
2. Select
Boresighting menu item. A crosshair shows in the center of the
view.
3. Press
or buttons to select one of 5 reticle type. Then press
button to confirm.
4. Press
, , and buttons to move the crosshair position. The
coordinate shows the current position of the crosshair.
5. Hold
button to save and exit.
FIGURE 2-7. BORESIGHTING