User's Manual

RATTLER TS35-640/TS50-640 USER MANUAL 21
The following languages are supported: English, Russian, German, Czech,
French, Spanish, Danish, Norwegian, Swedish, Finnish, Hungarian, Italian,
Polish, Portuguese, Romanian, Slovak, Spanish.
3. Hold
button to save settings and exit.
2.2.18 TRAJECTORY CORRECTION
Enable the trajectory correction to shot the target with high accuracy by
marking the offset between the big crosshair and small crosshair.
Trajectory correction available only with Reticle 1 type. Select Reticle 1 in the
Boresighting menu.
1. Hold
button to show the menu.
2. Select
Trajectory menu item. Two crosshairs show in the view. The big one
is reticle crosshair, and the small one is trajectory correction crosshair.
3. Set the distance.
1) Press
button, and then press or buttons to adjust the distance
between the target and the device.
2) Press
button to save the distance settings.
4. Set the crosshair position of trajectory correction.
1) Aim the big crosshair at the target.
2) Shot and mark the actual drop point of the bullet.
3) Press
, , and buttons to move the small cursor to the
position of the actual drop point. You can view the coordinate of the cursor
in the view.
5. Press
button to switch to the next distance.
6. Repeat step 3 to 4 to set another trajectory correction position.
You can save up to five corrections for different distances. Corrective aiming
points will be displayed with short lines on the reticle.
7. Hold
button to exit.
NOTE:
The scale of the Reticle 1 with trajectory correction marks changes
synchronously under the digital zoom.
2.2.19 TIME SYNCHRONIZATION
You can display the date and time on the screen. 24-hour and 12-hour time
format are available.
*-+96)86%.)'836='366)'8-32